enphase ClipperCreek TESLA, Руководство по установке

Страница: 4 / 28

Page 4
PEDESTAL INSTALLATION GUIDE
IMPORTANT SAFETY INSTRUCTIONS
BEFORE YOU BEGIN: Read these instructions completely, including the Safety Instructions. If you have questions about the use of this product,
contact your Service Representative.
NOTE TO THE INSTALLER: Be sure to leave these instructions with the user.
NOTE TO THE USER: Keep these instructions for further reference.
The TESLA® Wall Connector and ClipperCreek Electric Vehicle Supply Equipment (EVSE or “charging station”) are designed with the safety
concerns of the end user as an utmost priority; however, the following safety precautions must be read and followed:
•
The charging station and electrical wiring should be installed by a qualified electrician in accordance with local electrical codes and
ordinances.
•
Grounding Instructions - The charging station should be connected to a grounded, metal, permanent wiring system; or an
equipment-grounding conductor should be run with circuit conductors and connected to a grounding terminal or lead on the
charging station. Connections to the charging station should comply with all local electrical codes and ordinances.
•
Call your local service provider anytime a procedural question arises; DO NOT attempt to perform a procedure you are unsure of.
•
Read all installation instructions carefully before performing the pedestal and charging station installation.
EVSE PEDESTAL INSTALLATION GUIDE: TESLA® WALL CONNECTOR AND
CLIPPERCREEK HCS CONFIGURATIONS
• Single TESLA®
• Dual TESLA®
• Single ClipperCreek HCS
• Dual ClipperCreek HCS
•
Combo TESLA® and ClipperCreek
TOOLS REQUIRED FOR ASSEMBLING THE TESLA® WALL CONNECTOR
MOUNTING PLATE AND PEDESTAL
THE FOLLOWING TOOLS ARE REQUIRED FOR THE INSTALLATION AND ASSEMBLY OF THE TESLA® WALL CONNECTOR
MOUNTING PLATE COMPONENTS.
• T20 Torx driver
• T27 Torx Driver
• 5/16” Box Wrench
•
Ratchet wrench with 8mm Socket or 5/16” Nut Driver
• 5/16” Flathead Screwdriver (for Ground Block Lug)
• 1 ¼” (32mm) hole saw
• #2 Phillips Head Screwdriver
• 5/16” Flathead Screwdriver (for Ground Block Lug)
•
Box Wrench (appropriately sized for the Anchor Nuts)
TOOLS REQUIRED FOR ASSEMBLING CLIPPERCREEK HCS CHARGING
STATION AND PEDESTAL
THE FOLLOWING TOOLS ARE REQUIRED FOR THE INSTALLATION AND ASSEMBLY OF THE CLIPPERCREEK HCS
PEDESTAL COMPONENTS.
•
L-shape T27 Torx Driver (there are some tight spaces, advise using both the long and short T27’s for faster assembly)
• #2 Phillips Head Screwdriver
• 5/16” Flathead Screwdriver (for Ground Block Lug)
•
Box Wrench (appropriately sized for the Anchor Nuts)