Enova Technology Confidential
Page 5 of 5
X-Wall MX+ Dev Board Quick Guide Rev 1.1 10102015
JP5
GPIO4
0
Reserved
JP6
GPIO5
0
Close/Set to Vcc:
MX
＋
boots from
external SPI flash.
Open/Set to Ground (default):
MX+
boots from internal ROM.
Words of Cautions
To avoid unpredicted operational behavior and to enhance user’s experience of the MX+ development
board, please observe the following critical requirements:
1.
Use a reliable external power supply with 5 Volts and 3 Amps at least;
2.
Use premium SATA cables for a stable 6Gbps connection;
3.
Do not apply the power to your host and storage drive; and
4.
Ensure the following power on sequences are followed exactly:
4a. properly attach the power supply unit and use SW1 to power on the development board;
4b. Press and hold PB1 for at least a period of 3 seconds the release it; and
4c. Power on your host and storage drive
For occasion that the storage drive connected after the MX+ development board isn’t properly
recognized after you had performed above steps 1 through 4, power down your host and storage drive
then repeat the steps 1-4. Alternatively, contact your sales representatives to arrange for technical
support.
Quick installation with Enova I2C key fob
3
1.
Connect power adaptor;
2.
Connect SATA#2 connector to your motherboard SATA host adapter;
3.
Connect SATA#1 connector to your SATA storage device (SSD and/or Hard Drive);
4.
Insert Enova I2C key fob to the connector E;
5.
Power on the power switch B;
6.
Manually reset MX+ by pushing reset button H;
7.
Power on your system. The SATA disk drive should be recognized under OS.
3
Note that key format of the
X-Wall MX+
differs from that of the
X-Wall MX
. The old key format is not
compatible with the new
X-Wall MX+.
Consult Enova sales at
for the utility
program that generates new
MX+
key format and writes the key directly to the connected key fob.
