Filler
BACCO
11
5.4
“GE” MODEL WITH ELECTRIC FLOAT
Fillers Bacco GE with electric float have on the right side of the frame a switchboard connected to an external
pump or installed directly on the filler
(mod. GE-PE).
The floating system is constituted by two level probes, placed inside the tank, which control automatically the pump
connected to the switchboard. When the liquid level drops below the lower probe (MIN), the pump starts to fill the
tank; when the liquid level arrives at the upper probe (MAX), the pump switches off automatically.
5.4.1 Start up
To start up, you have to follow these steps:
1)
connect the power source cable
A
to the
electricity grid according to the data plate located on the
label;
2)
turn the switch off
I
on position
1
to give power to the switchboard (white light
T
on);
3)
at this point, the pump will be controlled automatically by the probes, depending on the liquid level
inside the tank (green light
M
on: pump in active use; green light
M
off: nonfunctional pump).
5.4.2 Switching off
To the switching off, you have to follow these steps:
1)
turn the switch off
I
on position
0
to take off power to the switchboard (white light
T
off);
2)
disconnect the power source cable
A
from the electricity grid.
POWER SOURCE
PROBE
PUMP
Содержание BACCO 2
Страница 1: ...FILLER BACCO 2 4 6 CONNECTIONS INSTRUCTION MANUAL AND SPARE PARTS ...
Страница 15: ...Filler BACCO 15 TAV I ...
Страница 16: ...Filler BACCO 16 TAV II ...
Страница 17: ...Filler BACCO 17 TAV III TAV IV ...
