EPAC – EnOcean People Activity Counter
Installation Guide
Copyright EnOcean © 2019
Page 4 of 4
EPAC_Installation_Guide_V1.4
If needed, an auxiliary 3-5 VDC power source can be used:
1.
Remove the sensor from the mounting plate and identify the
auxiliary power connector on the circuit board.
2.
Insert the + and - leads of a 3-5 VDC external power supply
into the appropriate 2 wire screw terminals.
3.
Remount the sensor on the mounting plate
Intended use:
This product is intended for indoor usage in closed dry rooms.
The product must not be used in any relation with equipment
that supports, directly or indirectly, human/animal health or life
or with applications that can result in danger for people, animals
or real value. The product is not suitable for use in mechanically
or environmentally challenging environments including (but not
limited to) environments with heavy vibrations, mechanical
shocks, very high humidity, very dusty or in explosive
atmosphere. The installation and assembly of electrical
equipment may only be performed by a skilled electrician.
Basic safety instructions:
Risk of suffocation! Do not leave the packaging material lying
around. Children could swallow the small parts and choke on
them. Install and operate product according to user manual and
do not modify product. The product should not be exposed to
rapid temperature changes shortly before or during operation;
condensation of moisture has to be avoided. Wrong cleaning
may damage the product; we suggest cleaning with soft and
damp tissue.
Disposal:
Product: Dispose of the used components at an official
collection point for electronic waste or at your local dealer.
Packing: Please use the recycling operators known to you.
Germany: WEEE-Reg.-No.: DE 93770561
Problem
Solution Checklist
Sensor does not
generate a wireless
message
▪
Press Set button to transmit motion message
▪
Verify the LED blinks when motion is detected
during a walk test
▪
Insert a battery and test again
Sensor is activated
when there is
nothing to detect
▪
Verify there is 1.5 m (4 ft.) clearance from heat
sources that may disturb sensing
▪
Reduce sensitivity setting by moving the PIR
sensitivity switch on the back from REG to
LOW (the left-hand position)
Linked device does
not respond to
wireless messages
▪
Force motion message by pressing Set button
▪
Check for environment or range issues
▪
Verify the device is linked
▪
Check the transceiver connection and the
wiring for errors
▪
Check if appropriate devices are linked
according to good system planning
868,300 MHz: contains: RE-D, RoHS, REACH
902 MHz: contains:
FCC: SZV-STM300U
IC: 5713A-STM300U
This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
WEEE-Reg.-No.: DE 93770561
EnOcean GmbH
Kolpingring 18a
82041 Oberhaching
Germany
Supplemental Power Supply (optional)
6
Savety Instructions
7
Troubleshooting
8
Agency compliance
9
