ENKHO 154835.01, Оригинальное руководство пользователя

Страница: 34 / 40

34
EN
1. Unroll the compressor hose 15 completely and
connect the compressor hose to the object that you
want to inflate. If necessary, use an adapter from
the adapter set 13 .
2. Open the lever 16 , put the hose valve 17 onto the
valve and press the lever down.
3. Switch on the jump starter by pressing the On/Off
switch 2 .
4. To set the air pressure (increase or decrease), press
and hold the Plus button 8 or Minus button 7 for
5 seconds.
− To increase the air pressure, press the Plus
button.
− To decrease the air pressure, press the Minus
button 7 .
5. To switch on the compressor, press the compressor
button 9 . The compressor will audibly start and
begin to pump.
6. To switch off the compressor, press the compressor
button again.
7. Open the lever and remove the hose valve from the
inflated object.
As the display of the jump starter is not calibrated,
check the new air pressure again with a calibrated
pressure gauge immediately after inflating, if
necessary.
15
13
16
17
2
8 7
7
9
1. Switch on the jump starter by pressing the On/Off
switch 2 .
2. To switch on the LED work light 1 , push the LED
button 4 .
3. To switch off the LED work light, push the LED
button again.
2
4
1
Switching the LED work light on
and off
Risk of injury!
The compressor of the jump starter
makes loud noises during operation
that can damage your hearing.
− Wear ear protection when the
compressor of the jump starter is
running.
Using the compressor
CAUTION!
8. Switch on the jump starter by pressing the On/Off
switch 2 .
9. For cars where the negative pole is earthed, attach
the red positive battery clamp to the positive pole
of the vehicle battery.
10. Attach the black negative battery clamp to the
motor, to the chassis (frame) or to another
earthed part of the car, away from the petrol line
and vehicle battery. Do not attach the black
negative battery clamp to the negative pole of the
vehicle battery because gases generated in the
vehicle battery could explode.
11. Press the jump-start button 3 .
The jump starter will check the readiness for
jump-starting for about five seconds and then
“OK” will appear in the display 5 .
12. If the vehicle battery is so weak that the ignition
light does not light up, wait 10 to 20 minutes
before attempting to start the motor.
13. Now start the engine. Do not attempt to start for
more than 1 second. Allow for a pause of at least
10 seconds after each start attempt. Do not start
more than 3 times.
14. As soon as the motor starts, switch off the jump
starter by pressing the On/Off switch.
15. Detach the black negative battery clamp first,
followed by the red positive battery clamp. When
removing the battery clamps, make sure that the
cables do not come into contact with rotating
parts of the engine.
16. Remove the jumper cable from the jump starter.
17. Wait after the motor has successfully started until
it runs smoothly. You have successfully jump
started the car.
2
3
5