ENKHO 154705.01, Оригинальное руководство пользователя

Страница: 24 / 53

EN
24
only the charger supplied.
●
Never charge non-
rechargeable batteries.
●
During charging the
batteries must be placed in
a well-ventilated area.
Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low noise operating modes as
well as wear personal protective equipment.
Take the following points into account to
minimize the vibration and noise exposure
risks:
¬ Only use the product as intended by its
design and these instructions.
¬ Ensure that the product is in good condition
and well maintained.
¬ Use correct attachments for the product
and ensure they are in good condition.
¬ Keep tight grip on the handles surface.
¬ Plan your work schedule to spread any high
vibration tool use across a longer period of
time.
Residual Risk
Even if properly operating and handling this
product in accordance with all the safety
requirements, potential risks of injury and
damage remain. Due to its construction and
build, this tool may present the following
hazards:
a) Electric shock from insufficient insulation.
Do not use the product when the product or
your hands are damp or wet.
b) Ear damage if working without ear
protection.
c) There is a risk of a short-circuit due to
liquid penetrating the housing. Do not
immerse the product and the accessories
in water. And make sure that no water or
other liquid can enter the housing.
d) Damage to your health caused by swinging
your hands and arms when operating the
tool for longer periods of time or if the tool
is not held or maintained properly.
Warning!
During operating, the product generates an
electromagnetic field which, under certain
circumstances, may impair the functionality
of active or passive medical implants. To
reduce the risk of serious or lethal injuries, we
recommend that persons with medical implants
consult their doctor and the manufacturer of
their medical implant before operating the
electric tool.
4. Before use
Unpacking
1. Unpack all parts and lay them on a flat
stable surface.
2. Make sure the delivery contents are
complete and free of damage. If you find
that parts are missing or show damage,
do not use the product but contact your
dealer or the service center. Do not use the
product unless missing parts have been
delivered in addition or defective parts
have been replaced. Using an incomplete or
damaged product represents a hazard to
people and property.
3. Ensure that you have all the accessories
needed for assembly and operation.
Charging the battery pack (Fig. B)
Note
◊ The battery can be damaged in case of
improper charging.
◊ Remove the charger's mains plug before
inserting or removing the battery.
The battery is partially charged upon delivery to
avoid damage to the battery caused by a deep
discharge. Prior to initial start-up and when the
battery is low, the battery should be charged.
To do so, please proceed as follows (Fig. B):
1. Slide the battery pack (4) onto the charger
(15) upside down till it locks in place.
2. Insert the mains plug of the charger(15)
into a properly fused mains socket. The RED