18
ENEN
•
Place the lager container (L) underneath the juice dispensing spout with closing cap (H), place
the small container (O) underneath the relevant Pulp ejecting spout (P), Fig. 7.
•
Insert the food previously prepared in the lid (C) through the cap (B) closed. Position the presser
(A) close to the hole on the cap (B), Fig. 8.
warning:
The filter (E) has small sharp blades for chopping food. Be careful not to get hurt while removing
or cleaning the filter.
warning:
Should the lid (C) and the bowl (G) be mounted improperly, the juicer does not start. In this case
the motor does not run, even though the on/off button (H) is on “ON” position. Make sure all
components are properly mounted before use.
Switching on
•
Position the switch button (I) to “ON”. The motor start running. Open the cap on the juice
dispensing spout (H).
•
Put the food into the lid (C) piece by piece, slightly press the food presser (A) to bring food
towards the filter (E). Do not put too much food into the appliance and do not excessively press
on the food presser (A).
warning:
Try to avoid the food presser (A) get contact with the pressing screw (D) during operation.
•
By positioning the switch button (I) to “REV”, the motor changes direction of rotation for a bet-
ter juice extraction. Keep one hand to hold the lid (C) as the counterclockwise may caused the
lid (C) to open, the appliance will stop running then.
warning:
Do not change the switch button (I) position quickly, keep remain on ”0” position for few seconds
then switch.
warning:
This appliance is not designed to work in a continuous mode. Let the motor cool down after 20
minutes of continuous functioning.
•
Once having processed the first load of food, repeat the above steps to make some other juice
(if you remove it immediately some drop of juice will continue come out).
7
8
