ENJI PRIME EyeBall Cam, Быстрый старт

Страница: 3 / 16

CHARGING
Before use, fully charge the built-in rechargeable lithium
battery first for about 2 hours. The camera works even while
charging.
Notes:
Red LED light is on while charging, once fully charged, red
LED light turns off. If image is not clear, this means the
battery is low. Charge the battery first for 2 - 3 hours. Battery
life is about 60 minutes.
POWER ON / POWER OFF
Press ON/OFF button once to power the camera on.
To power off, press and hold the ON/OFF button for 5
seconds. The red and yellow indicators will turn off .The
Camera is now off.
INDICATORS & MODES
After connecting the battery/charger to the camera, press
the ON/OFF button to power on the camera
.
1. Red LED indicates that the camera is charging.
2. P2P(AP) mode: Blue LED lights on, yellow LED flashes
slowly
3. Remote IP Mode: Blue LED lights on, yellow LED
flashes quickly for a few seconds then always stays ON
NOTES:
1. Once you have configured remote IP mode, yellow LED
is lighted and stays ON. Under any mode, the camera
can be reset to P2P Mode.
2. Press the reset key about 5 seconds until all lights go
OFF, if the camera boots up again, reset is successfull
(about 30 seconds).