1. Door removal
(a) To make installation easier remove cabinet
doors & shelves. To release a hinge, press
button at rear of hinge and unhook from bracket.
INSTALLATION
TOOLS AND MATERIALS REQUIRED - (Not Supplied)
INSTALLATION INSTRUCTIONS
VALENCIA
TM
Tower Cabinet
ENGLEFIELD
5mm drill bit
TOOLS
MATERIALS - Not supplied.
Fixing Washers
20mm
10g x 50mm
Pan head
Screws
To suit screws
Hook
Button
3. Shelf position adjustment
(a) Three shelves have adjustable positions.
Once shelves are in position, use plastic clamps
to lock in place.
NOTES: Refer to construction requirements
section before proceeding.
- A minimum of
6 fixing points
is recommended
- Screws: Pan head (10g x 50mm).
- Washers: Flat (20mm). (
Must be used to spread load).
(a) Choose an appropriate location. Determine
positions of nogs/studs in wall and
check that wall is free of bumps/protrusions.
(b) Using a spirit level, draw a line on wall to mark
location of top of cabinet. 1800mm from floor
is recommended.
(c) Determine locations of fixing points and mark
them on back of cabinet.
NOTE:
Make sure fixing points are located
at least 60mm from cabinet edge and away
from fixed shelves, preferably just underneath
adjustable shelves.
(d) Using a 5mm drill bit, drill clearance holes
through cabinet back at marked positions.
(e) Place cabinet in chosen location and support.
Make sure cabinet is plumb using a spirit level.
(f) Fix cabinet to wall
using recommended
screws and washers.
2. Fixing the tower cabinet to the wall
200
POSSIBLE FIXING
POINT LAYOUT
Fixing points
x 6 minimum
Recommended
installed height
Adjustable
shelves
Shelf
Metal pin
Plastic
clamp
3
Stud finder
