BEFORE YOU BEGIN
1397399-AN2-A 06/07/2019
INSTALLATION
INSTRUCTIONS
TAPWARE
ENGLEFIELD
STUDIO II
SLIDE SHOWER
All information is based on the latest product information available at the time
of publication. Englefield reserves the right to make changes in product charac-
teristics, packaging, or availability at any time without notice.
Please leave this installation instructions guide for the consumer.
It contain important information.
NOTES:
ROUGH-IN DIMENSIONS
CONTACT AND WARRANTY INFORMATION
SPARE PARTS LIST
NEW ZEALAND
KOHLER NZ LTD
Free Ph: 0800 100 382
Free Fax: 0800 664 488
www.englefield.co.nz
AUSTRALIA
KOHLER AUSTRALIA
Free Ph: 1 800 ENGLEFIELD
(1 800 364 533)
www.englefield.com
For warranty information, please visit our website
Page 4
1397399-AN2-A 06/07/2019
ENGLEFIELD
INSTALLATION INSTRUCTIONS
STUDIO II SLIDE SHOWER
22980A-CP
22981A-CP
29689A-CP
1. Flush the water supply pipes thoroughly to remove debris.
2. An in-line filter must be used with this product.
3. The working pressure of hand shower is between 100 kPa and 500 kPa.
If it exceeds 500 kPa, a pressure limiting valve must be fitted.
4. The operating temperature of hand shower is from 10
˚C
to 70
˚C
. NZ
building code G12 requires that maximum hot water temperature at any
sanitary fixture used for personal hygiene shall not exceed either 45
˚C
or
55
˚C
. If so, a tempering valve must be installed.
5. This shower is intended for high/mains pressure installations. It may not
be suitable for use with gravity-fed water heaters, low and unequal pres-
sure supplies.
6. All installations should comply with local plumbing codes and the relevant
requirements of AS/NZS 3500 and AS/NZS 6400.
700
Max 620
G 1/2”B
G 1/2”B
225
Ø 50
Ø 90
1524
G 1/2”
* All measurements shown are in milimetres
Elbow
1358461-CP
Cap
1239238
Soap dish
1239246
Clamp bracket
1239242
Shower hose
1241297
Hose washer
1239241
Mounting bracket kit
1239236
Taper block
1239247
Hand shower
(single mode)
1397397
Hand shower
(multi modes)
1397398
