(e) Apply sealant
(not supplied)
around screw
holes on rear side of wall retainer.
± 0 mm
3 mm
LH opening
RH opening
x4
2.1 Wall Retainers and Door
Caution:
Ensure tray or tiled floor is
level & walls are vertical & square.
(a) Mark the locations of the wall retainers.
For tray base option:
- Mark 10mm in from top edge of tray.
For tiled floor option:
- Mark from back wall to outer edge
of both retainers with your preferred
dimension ‘A’.
(c) Position a wall retainer on ‘hinge side’
wall with flat side facing outwards. Use a
level to make sure it is upright. (This is
critical to ensure correct operation of the
door).
(b) This shower is reversible. Please
choose which side you would like the
door to open from.
(d) Mark position of fixing holes, then
remove wall retainer and drill holes
using an appropriate 3mm drill bit
(not supplied).
LH opening shown
Tip:
Cover the waste to prevent the loss of
small parts. If installing onto a tray protect
the tray surface during installation.
2 - INSTALLATION
Page 5
10 mm
10 mm
x4
± 0 mm
A
INSTALLATION INSTRUCTIONS
MILANO Alcove
