845
2
3
How to Install the Slide Bar
INSTALLATION
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tightened.
Turn on main water supply & check for leaks.
Repair as needed.
Select a location on a vertical wall to install shower column according to rougn-in dimensions.
Note: Min 350mm from ceiling to top mounting position.
Mark wall for top mounting position.
Measure 840mm vertically down and mark
lower mounting position. Drill a hole at both positions.
Fix mounting brackets (1) to wall using screws. Align slot on top of
mounting bracket horizontally, and bottom mounting bracket vertically.
Screw lower tube (5) into top tube (3) through top support (4) - hexagonal
shape. Insert additional support (12) - round shape - if required for a retro-fit.
Attach diverter (7) to shower column assembly.
Connect assembly to brackets and tighten grub screws to hold in place.
Insert supplied rubber washers into water supply hose (600mm) ends.
Connect water supply hose to front inlet (9) of diverter and to elbow (10).
Insert supplied rubber washers into hand shower hose (1.5m) ends.
Connect to back outlet (8) of diverter and to hand shower (11).
Run hot and cold water for a minute to remove any debris.
Attach shower head (2) to top tube (3).
Ensure that all connections are sealed properly.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Englefield faucets and fittings.
4
1
1
5
6
9
11
10
8
7
Page 2
1217518-A02-
D
17/07/2014
Englefield
INSTALLATION INSTRUCTIONS
STUDIO
Dual Rain Shower
12
