IMPORTANT!
READ AND FOLLOW
ALL
INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
19
Convection Blower
The Convection (room air) Blower (Part #
PU-4C447
) is located on the left side of the unit and can
be removed by disconnecting the power leads and removing the four mounting screws. Once this is
done, the blower will slide out of the stove. This procedure can be reversed to install a new blower.
Combustion Blower
To replace the Combustion (exhaust) Blower (Part #PU-076002B), the power leads and the pellet
vent pipe must be disconnected. Next, remove the screws that hold the blower to the steel exhaust
tube and slide the blower from the stove.
Note:
There is a Combustion Motor Gasket (Part PU-
CMG), which allows you to remove the motor from the Combustion Blower housing, clean your stove,
and replace the motor and gasket without having to remove the entire Combustion Blower. If cleaning
your blower, the blower impeller, blower tube and steel blower exhaust tube on the unit should be
brushed and vacuumed. However, if you must remove or replace the entire Combustion Blower, a
new blower flange gasket (Part # PU-CBG) should be added between the blower flange and the steel
exhaust tube.
Vacuum Switch
This unit is equipped with Vacuum Shut Down Switches (Part #
PU-VS
and
CU-VS
), which help
control various functions of the unit. If an operational error occurs in the unit, a switch will either stop
the top (feed) auger or shut the unit off; if the unit turns off an
E-1
Code (error code) will appear in the
Heat Range and Blower Speed windows of the Control Board. Situations which could cause this
include power failure, Combustion Blower failure, improper flue installation, a blocked flue (from
rodents, nests, etc.), or “dirty burning” from burning improper fuel (see “Important Information” at the
beginning of the manual).
“Door Ajar” Vacuum Switch Port
If necessary, remove right side louver
to determine where vacuum port enters
firebox
Inside right wall of firebox
NOTE: The "door ajar" vacuum switch port must be kept clean, or the top auger will cease to function.
Locate the port hole on the right wall of the burn chamber (you may remove the right louver to follow the
vacuum tube to locate the hole) and, with the stove unplugged and cooled down, use a brush or pipe
cleaner (not a vacuum) to keep this port clear of ash or other debris (see picture).
Содержание 25-PDV
Страница 32: ......