001-01-000092 Rev. 000
Page 4 of 5
E. Optional Side Plate Installation
Threaded holes on both sides of the WR-10U23 frame
allow an optional side plate (Model SPL-4H) or additional
cable guides to be installed to expand cable
management. The SPL-4H provides two split and
adjustable take-up reels, as illustrated in Figure 5.
To install and use the SPL-4H side plate, refer to Figure
10 and the steps below.
Slide the two narrower tabs at the edge of the SPL-4H
into the openings on the side of the WR-10U23,
toward the rear of the mounting.
Align the wide tabs at the front edge of the SPL-4H
with the threaded holes on the side of the WR-10U23
frame. Use the two (2) included #10-32 x 3/8
” screws
to securely fasten the side plate to the frame.
Carefully wrap cables around the take-up reels to
reduce slack as needed. Example routing is shown in
Figure 11. Alternate mounting holes are included on
the side plate for repositioning the half-reels, if desired.
5. TESTING AND TROUBLESHOOTING
Equipment installed in the WR-10U23 should be tested
according the manufacturer’s instructions.
6. CUSTOMER SERVICE
Customer Sales and General Support
Monday through Friday, 8:00 a.m.
– 5:00 p.m. CST
Toll Free: 800-980-ECOM (3266), Local: 630-444-0778
24/7 Sales Support: [email protected]
24/7 Technical Support:
Toll Free: 800-841-1005
E-mail: [email protected]
Enginuity Communications
3545 Stern Avenue
St. Charles, IL 60174
Figure 9. Cable guide application
Figure 10. SPL-4H installation
Figure 11. Cable take-up reel routing
