P
GH Manual
IOM-62
5 of 9
Nov 17 R1
PARTS
Contact the nearest Engineered Air sales office or factory for replacement parts. Be sure to include
Model Number, Serial Number, date of installation, the nature of the failure and the description of the
part(s) required. Some parts may not be stocked items and must be manufactured or ordered.
RECEIVING
Refer to the back of the packing slip for receiving instructions.
On receipt of the unit, check for damage. Inspect protective covers for punctures or other signs that
there may be internal damage. Remove protective covers and check for internal damage. Replace
covers if the unit is not being installed at this time. Open access doors and check for internal damage.
Close access doors when inspection is complete.
All units are pre-tested at the factory immediately prior to shipping and are ensured to be in good
operating condition at that time. If damage is found, refer to the instructions on the back of packing
slip.
On receipt of the unit, check the electrical characteristics (see rating plate) to make sure that the
electrical supply matches. All parts for field installation are listed on the shipping order form.
TEMPORARY STORAGE
If a unit is to be stored prior to installation the following precautions are required:
Store in a well drained area that will not accumulate surface water.
Store in an area where the unit will not be damaged.
All protective coverings that were provided for shipping must be in place.
Protect indoor mounted equipment from rain and snow.
INSTALLATION
Warning:
This unit is not explosion proof. It is not suitable for hazardous locations as defined
by the National Electrical Code of the Canadian Electrical Code.
m
Warning:
All wiring and piping installation must be completed by qualified technicians in
accordance with all federal, state, provincial and/or local codes.
m
Note: Installation shall be in accordance with this manual and all other associated component and
control Installation, Operation and Maintenance Manuals.
