ENGINDOT GPW3400, Руководство пользователя

Страница: 18 / 27

17
6.3 Starting Engine
See Section 5.3 Starting Pressure Washer
to start the pressure washer.
Follow these instructions to safely start
your pressure washer:
1. Check engine oil level; fill to recommended
level if necessary. Check gasoline level fill if
necessary. Fig. A
2. This pressure washer comes with a pump
quick connect coupling. It allows you to quickly
connect or disconnect the garden hose from the
pump. Pulling the mid ring will disconnect the
quick connect coupling. Connect garden hose to
the pump quick connect coupling and TURN
WATER ON. The water supply must provide a
minimum of 4 GPM at 20 PSI or the pump may
be damaged. Fig. B
3. Squeeze gun trigger. This will allow air to
escape from the hose in order to prime the
pump. Squeeze trigger until there is a steady
flow of water. Fig. C
4. Turn
engine switch to the “On” position. Fig. D
5. Open
fuel valve (“On” position). Fig. E
6. Close the Choke lever by moving the lever to
the “CLOSE” position. Fig. F
7. Locate recoil cord and pull slowly until
resistance is felt. At this point, pull rapidly to
start engine. Repeat if necessary. Fig. G
8.Once engine starts, moving the lever to the
“
Open
”
position. Fig. H
If motor fails to start, repeat steps 3-8. Fig. I
6.4 Stopping Engine
1. To stop the engine move the choke lever to the
CLOSE position and then set the engine I/O switch to
O position.
2. Finally move the fuel valve to OFF position.
CAUTION
Return the starter cord handle gently to its starting
position to prevent damage to the starter .
IMPORTANT,
Before each use:
• Check the oil and fuel level and fill if necessary.
• Make sure that spark plug, muffler, fuel cap, and air
filter are in place and secured.
• Do not crank engine with spark plug removed.