EnGenius EPG600, Руководство пользователя

Страница: 55 / 138

55
Configuring PPPoE
Point-to-Point Protocol over Ethernet (PPPoE) is used mainly by
ISPs that provide DSL modems to connect to the Internet.
To view the PPPoE settings, click
Internet
, then click
PPPoE.
Username
Enter the username assigned by an ISP.
Password
Enter the password assigned by an ISP.
Service Name
Enter the service name of an ISP (optional).
MTU (Maximum Transmission Unit)
Enter the (MTU). The MTU specifies the largest packet size
permitted for an internet transmission (PPPoE default: 1492).
The MTU size can be set between 512 and 1492.
Authentication Type
Select the type of authentication provided by the ISP: Auto, PAP,
or CHAP. If unsure of the best setting, select Auto or check with
your Internet Service Provider.
Type
Configure the connection type between the router and the
ISP. Select one of the following:
Keep Connection , Automatic
Connection
or
Manual Connection
.
Idle Timeout
Configure the maximum idle time (1 to 1,000 minutes) allowed
for an inactive connection.
Clone MAC
Enter the MAC address of the devices’ network interface
card (NIC) in the MAC address field and click Clone MAC.
Note: Some ISP providers require registering the MAC address
of the network interface card (NIC) connected directly to
the cable or DSL modem. Clone MAC masks the router’s
MAC address with the MAC address of the computer’s NIC.
Click Apply to save the settings or Cancel to discard the
changes.