Version3.0
EnStation5-AC Kit
EnStationAC Kit
ENH500 Kit
Device*2
Screw Set*2
Pole Mounting
Strap*2
Bracket*2
Sealing nut*2
Dynamic Stick*2
PoE Adapter*2
Power Cord*2
EnStation5-AC
EnStationAC
1
Connecting the Device
A
E
B
B
D
A)
B)
C)
D)
E)
Remove the rear bottom panel.
Connect one end of the Ethernet cable into the LAN(PoE) port of the
device and the other end to the PoE Port on the PoE Adapter.
Connect the Power cord to the PoE Adapter and plug the other end
into an electrical outlet.
Connect the second Ethernet cable into the LAN port of the PoE
Adapter and the other end to the Ethernet Port into the computer.
Place the panel removed from step A back onto the device.
Note:
+ The device should ONLY be powered via Ethernet cable connected
to included PoE Adapter. EnStation5-AC/ENH500: Support proprietary
24V PoE input. EnStationAC: Support proprietary 54V PoE input
+ For EnStationAC : The 2nd Ethernet port of the device can supply
the 802.3af power source when used with the included PoE Adapter.
This kit is pre-configured in AP (Master, 192.168.1.1) and CB (Remote,
192.168.1.2) mode. Wireless connection will be built
automatically once the
devices are powered up.
You must know :
computer
)
IP Address Configuration
2
A)
EnStationAC
To configure the device, open a web browser and enter IP
address as below.
A)
3
Device Setup
-
IP: 192.168.1.1
If the last two
digits of the serial number
on the device label is -1.
-
IP: 192.168.1.2
If the last two digits of the serial number
on the device label is -2.
B)
A login screen will appear. By default, the username of the
device is
admin
and the password is
admin
. Enter the current
username and password of the device and then click
Login.
Note:
The model name on login screen depends on the product
you are using.
You can also use the EnWiFi App and
connect to the management SSID which
is on the device label and GUI to configure
the device. The default Wi-Fi password is
12345678.
C)
Configure on GUI
4
Switching Modes
A)
The device can operate in the following modes.
EnJet enabled: Access Point, Client Bridge, WDS AP, WDS Station.
EnJet disabled: Access Point, Client Bridge, WDS AP, WDS Bridge,
WDS Station.
Note:
The model name on login screen depends on the product
you are using.
EnStationAC
EnStationAC
EnStationAC
EnJet
EnStationAC
B)
C)
Use EnWiFi App, open configure
→
Wireless
to setup the Operation
Mode.
* It may take up to 90 seconds for device to initially power up.
Click on the
Wireless
link under the
Network
and setup the
Operation Mode.
Configure on EnWiFi App
ENH500
PoE Adapter*2
Device *2
Pole Mounting *2
Wall Mount
Screw Set *2
Waterproof *2
Power Cord*2
