Engel RC5320HD, Руководство пользователя

Страница: 33 / 34

135
ENGLISH
Note : If you have tried all of the actions suggested above, without solving the problem, please contact your
dealer or service provider.
TROUBLESHOOTING
Problem Possible causes What to do
The display on the front panel
does not light up Main cable is not connected Chack that the main cable is
plugged into the power socket
No sound or picture, but the
front panel shows red light The receiver is in standby mode Press the standby button
No sound or picture. The satellite dish is not pointing
at the satellite Adjust the dish. Check the signal
level in the Antenna Setup
MENU
No signal or weak signal Chck the cable connections, LNB
and other equipment connected
between the LNB and the recei-
ver, or adjust the dish
The satellite dish is not pointing
at the satellite Adjust the dish
Signal is too strong Connect a signal attenuator to
the LNB input
Satellite dish is too small Change to a larger dish
Bad picture/blocking error LNB noise factor too high Change to an LNB with lower
noise factor
The LNB is faulty Change the LNB
The picture is not
showed on the screen,
when switching on. The system is connected by RF
leads. Check the UHF channel fixed in
your system and tune the UHF
channel properly.
There is interference on
your digital satellite
channels, an existing
terrestrial channel or video
signal. The system is connected by RF
leads and the output channel of
the receiver interferes with an
existing terrestrial channels or
Video signal. Change the receiver output
channel to a more suitable
channel, or connect the system
by SCART leads.
Battery exhausted. Change the batteries.
The RCU is not working. RCU is incorrectly aimed. Aim RCU at the receiver, or check
that nothing blocks the front
panel.