ENFORCER Indoor Proximity Card Reader
SECO-LARM U.S.A., Inc.
13
Advanced Programming (continued):
Programming the Door Unlock Mode (cont.):
To program the reader for timed output mode:
Step Action
Reaction
1
Tap the master card 3 times
Blue status LED flashes, and LED 3 turns
to a steady ON
2
Wait 2 seconds
2 Beeps, then LEDs 1 and 2 flash
3
Press the “Bell” button twice
LED 2 turns to a steady ON to indicate
that the door lock output is in timed output
mode
4
Wait 2 seconds
2 Beeps confirms that timed output mode
was set
5
Press the “Bell” button once to start a
60-second timer
Count the number of beeps – 1 beep
equals 1 second of door unlock time;
count until the number of seconds
required is reached
6
Press the “Bell” button again to stop the
60-second timer
Beeps stop; the door unlock time has
been set
7
Exit programming by tapping the master
card once
2 Beeps
Programming System Lockout:
The ENFORCER PR-312S-PQ Indoor Proximity Card Reader can be programmed to temporarily
lock out user cards if non-programmed user cards are used. There are three possible modes:
1.
No system lockout (default mode) (option 1)
2.
Stop accepting user cards for 60 seconds after 10 false tries (option 2)
3.
Stop accepting user cards for 15 minutes after 10 false tries (option 3)
Step Action
Reaction
1
Tap the master card 4 times
Blue status LED flashes, and LED 4 turns
to a steady ON
2
Wait 2 seconds
2 Beeps, then LEDs 1, 2, and 3 flash
3
Press the “Bell” button once for option 1,
twice for option 2, or three times for
option 3
LED 1 turns to a steady ON to confirm
option 1 is set
LED 2 turns to a steady ON to confirm
option 2 is set
LED 3 turns to a steady ON to confirm
option 3 is set
4
Wait 2 seconds
2 Beeps confirms that the selected lockout
mode was set
5
Exit programming by tapping the master
card once
2 Beeps
NOTE:
When using a user card to unlock the door, if more than 30 seconds pass after a false
trial, the 10-trial counter restarts.
