background image

ENFORCER HDMI Extender over Two Wires 

8

 

SECO-LARM U.S.A., Inc. 

HDMI device does not function correctly 

 

Verify the extender is powered on both sides 

 

Verify the source and the display are powered 

 

Test the two conductor wires between the receiver and 
transmitter to confirm they are functional 

 

Verify that there are no problems with the HDMI source, 
HDMI cables, or HDMI display by plugging the source 
directly into the display using an HDMI cable 

 

Do not bundle cables when connecting multiple receivers 

Screen flickering or brief image loss 

 

Switch the source device to a lower HDMI output 
(e.g., 1080p to 1080i) 

 

 

 

 

HDMI Extender over  

Single Cat5e/6 

HDMI Extender over 

Single Cat5e/6 

High-Speed  

HDMI Cables 

 

 

 

MVE-AH030Q MVE-AH1E1-01NQ

 

MC-1130-xxFQ

 

4K HDMI Splitters 

HDMI Extender over IP 

Enhanced HDMI Extenders 

over Single Cat5e/6 

 

 

 

MVD-AH1x-01Q MVE-AHMPM-01NQ

 

MVE-AH1H1-0xxQ

 

Also Available from 

SECO-LARM

®

:  

Troubleshooting:  

SECO-LARM

 

®  

U.S.A., Inc.

 

16842 Millikan Avenue, Irvine, CA 92606 

Website: www.seco-larm.com 

Phone: (949) 261-2999  |  (800) 662-0800  Email: [email protected] 

®

 

PICLN3 

 

MI_MVE-AH1T1-01YQ_180122.docx 

NOTICE: 

The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM 

reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks 
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2018  SECO-LARM U.S.A., Inc.  All 
rights reserved.  

WARRANTY:

 

This SECO-LARM product is warranted against defects in material and workmanship while used in normal 

service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or 
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if 
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, 
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment 
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of 
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s 
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property 
damage of any kind to the purchaser or anyone else. 

HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing 

LLC in the United States and other countries. 

Содержание MVE-AH1T1-01YQ









Отзывы: