ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Vandal Dome Camera
SECO-LARM U.S.A., Inc.
3
Overview
To adjust the zoom and focus, open the Zoom/Focus
compartment located in the camera body. Use a flathead
screwdriver to loosen the zoom and focus screws to allow for
adjustment.
Focus
To focus in on close objects, push
the focus screw right towards "N".
To focus out on far objects, push
the screw right towards "F".
Zoom
To zoom in, push the zoom screw
left towards "T". To zoom out, push
the screw right towards "W".
OSD Controller Settings:
To set format via the OSD controller, move the
controller in the direction of the desired setting,
hold for 5 seconds, and release when the
camera restarts.
See chart below.
Direction Format Setting
Up
AHD
Down CVBS/Analog
Left TVI
Right CVI
UP
NOTE:
Do not press joystick in when setting different modes.
1.
Undo the 4 screws on the side of the dome cover
using the included hex wrench.
2.
Remove the dome cover from the base.
3.
Temporarily connect the camera's female BNC
connector to a monitor.
4.
Temporarily connect the camera's DC jack to a
12VDC power supply.
5.
While watching the monitor, hold the camera
against the wall or ceiling by hand where it is to be
mounted, then adjust the camera until it is certain
that the mounting location is correct. Mark that
location with a pencil.
6.
Adjust the zoom and focus to desired settings. See
"Zoom and Focus Adjustment".
7.
Use the OSD controller's joystick to adjust the
camera settings. See "OSD Controller Settings".
(For more information, see separate OSD
manual).
8.
Mount the camera mounting base to the wall using
the included mounting screws, making sure the
bottom of the base sits flush against the wall.
9.
Run a hidden, permanent video cable from the
monitor to the camera.
10.
Run a hidden, permanent power cable from a
12VDC power supply to the camera.
Installation:
Zoom and Focus Adjustment:
Zoom
Focus
Mounting base
OSD Controller DC jack
Female BNC
connector
Retaining Wire
Zoom/Focus
compartment
Cover Screw
Dome cover
Important:
Do not cut any wires as the warranty will be voided.
BNC
Connector
Camera
1.
Use the camera within the given temperature
and voltage limits.
2.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
3.
Do not subject the camera to strong vibrations.
4.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
Before Starting:
(Continued next page)
