ENFORCER Passive Video Transceivers
8
SECO-LARM U.S.A., Inc.
Troubleshooting:
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800/ 949-261-2999 Fax: 949-261-7326
Website: www.seco-larm.com
E-mail: [email protected]
PICFN1
MiEB-P1xx-01_1211.docx
The screen is blank
Check that the monitor is powered up.
Check that the CCTV camera is powered up.
Check that the video cable connecting the camera to the
transceiver is connected properly.
Check that the cable(s) connecting the transceiver to the
monitor, switcher, DVR, or multiplexer are connected properly.
Double-check the connections to any passive or active baluns.
The screen image is dim
Clean the camera lens (using a soft, clean cloth).
Check that the camera light source is adequate.
Clean the camera dome (if applicable).
If the backlight control (BLC) DIP switch on the camera is set to
OFF, try setting it to ON.
The screen image is dark
Check that the automatic electronic shutter (AES) DIP switch on
the camera is turned OFF.
The screen image has poor contrast
Adjust the monitor’s contrast knob.
Change the position of the camera so that the scene is better lit.
The screen image flickers
Check all connections.
Change the position of the camera so that the scene is better lit.
The screen image rolls
If multiple cameras are used, make sure the polarity of the power
connections is consistent.
The screen image is distorted
(24VAC only) If more than one camera is attached to the same
power source, adjust the other camera’s linelock sync.
Change the position of the camera.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy
is one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice.
SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2012 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without
the written permission of SECO-LARM.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a
period of two (2) years from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not
operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any
kind to the purchaser or anyone else.
WARNING:
Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a dangerous electric shock,
damage the device, and void the warranty. Do not open the case of this device, as there are no field-serviceable components inside.
IMPORTANT:
Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws
and statutes related to monitoring and recording audio and video signals. SECO-LARM
will not be held responsible for the use of this
product in violation of any current laws or statutes.
