ENFORCER 35ft Retro-Reflective Photoelectric Beam Sensor
4
SECO-LARM U.S.A., Inc.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for 1 (one) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
®
PITJW3
MI_E-936-S35RRGQ_160912.docx
Optional Accessories Available from
SECO-LARM
®
:
E-931ACC-R2Q
Square Reflector
E-931ACC-RC1Q
Round Reflector
E-931ACC-HR1Q
Reflector Hood for
Round/Square Reflector
E-931ACC-BLR2Q
Reflector Bracket
E-931ACC-BLS1Q
Sensor Bracket
E-931ACC-BLS7Q
Wall Bracket
E-931ACC-BLS8Q
Door Frame Bracket
E-931ACC-BLS6Q
Single-gang Bracket
Sensor does not detect the object.
Change the angle of the sensor or readjust the sensitivity setting
Yellow LED does not turn on
Clean the sensor and reflector with a damp (not wet) cloth
Adjust the reflector and/or sensor for proper alignment
LEDs turn off when object is
detected, but no output
No continuity between sensor and alarm device. Check cable from
sensor to alarm device. Test sensor.
Troubleshooting:
Optional Accessories Available from
SECO-LARM
®
:
E-931ACC-R2Q
Square Reflector
E-931ACC-RC1Q
Round Reflector
E-931ACC-HR1Q
Reflector Hood for
Round/Square Reflector
E-931ACC-BLR2Q
Reflector Bracket
E-931ACC-BLS1Q
Sensor Bracket
E-931ACC-BLS7Q
Wall Bracket
E-931ACC-BLS8Q
Door Frame Bracket
E-931ACC-BLS6Q
Single-gang Bracket
Sample Installations:
Garage Door
Main Entrance Door
Store Entrance
Parking Distance Monitor
Entry Gate
