ENFORCER VIDEO DOOR PHONE
5
Jumpers x 3
Not Used
6. Plug the AC Power Adapter’s cable into the
“Power” socket on the back of the monitor.
7. Run the wires going to the camera under
the plastic hooks on the back of the monitor
so that any tension on them will not be
directly transferred to the plugs or sockets.
8. Plug the AC power adapter into a 120VAC
socket.
9. Test the monitor and camera unit by
pressing the camera button. The image in
front of the camera should be displayed
clearly.
Note: Please use the Wire Connection Chart
included on the front cover of this
manual to write in the color of the wires
being used. This can be used as a
reference when installing the camera.
Make sure wire connections between
monitors and cameras are all connected
correctly before powering the unit.
10. If using a secondary monitor, follow steps
1-4 on page 4.
11. Plug the brown 4-pin plastic connector
from the camera into the “Main Monitor”
socket (see Figure 3).
NOTE: There will be an unused socket
on the back of the secondary monitor.
12. Follow steps 6-9 above to complete the
installation
Figure 2 – Back of Primary
Monitor Detail
Monitor
2
Camera
2
Not
Used
Camera
1
Camera 2 and Monitor 2 sockets are
used only with optional additional
monitor or camera (discontinued).
Figure 3 – Back of
Secondary Monitor Detail
Main
Monitor
Not
Used
Power
SECO-LARM U.S.A., Inc.
Power
ENFORCER VIDEO DOOR PHONE
8
Operating Instructions (cont):
Monitoring the entrance:
1. To see and hear what is going on at the
entrance, lift the handset and press the
Camera Button. The camera and monitor will
automatically switch on.
2. If an additional camera is installed,
pressing
the Camera Button a second time will
switch the image displayed on the monitor to
the view from the other camera. Pressing the
camera button again will turn off the cameras.
3. When finished, simply hang up the handset
and the camera will switch off. If the handset is
not hung up, the camera will automatically
switch off after 2 minutes.
LED Indicator:
Installing a Second Monitor:
A status LED indicator is located on
the front of the monitor. The LED
displays power information as well as
the status of the handset.
LED Indicator
Green LED
– Solid green LED
indicates standby mode. Flashing
green LED indicates camera “on”.
(2 monitors only)
Red LED
– Solid red LED indicates
standby mode. Flashing red LED
indicates camera “on”.
Dimensions:
ENFORCER
7
11
/
16
(196mm)
3
15
/
16
(100mm)
5
1
/
4
(134mm)
1
1
/
2
(38mm)
9
5
/
8
(245mm)
3
1
/
8
(79mm)
®
ENFORCER
Camera Button
SECO-LARM U.S.A., Inc.
Note: Make sure wire connections between monitors and cameras are all connected correctly.
E4
E3
E2
E1
E4
E3
E2
E1
E1
E2
E3
E4
E1
E2
E3
E4
E4
E3
E2
E1
E4
E3
E2
E1
-----
-----
-----
-----
-----
-----
-----
-----
-----
-----
-----
-----
E4
E3
E2
E1
E4
E3
E2
E1
