ENFORCER 100LB/100CB
Owner's Manual
Page 9
ANTI-CARJACK PROTECTION (optional)
A. Enabling the ANTI-CARJACK function:
If the ANTI-CARJACK toggle switch is not
installed, you cannot use the ANTI-CARJACK
function (please ask your dealer).
To enable the ANTI-CARJACK
function, put the ANTI-
CARJACK toggle switch to the
ON position. If the ANTI-CARJACK
toggle switch is OFF, the ANTI-CARJACK
function cannot be entered.
Once the ANTI-CARJACK function is
enabled, you can disable it by turning the
ANTI-CARJACK toggle switch OFF. However,
this must be done before you turn the
ignition ON.
B. Stages of the ANTI-CARJACK mode:
1. Stage 1
a. ANTI-CARJACK is triggered if
someone opens and closes a door
while the ignition is ON. Once
ANTI-CARJACK is triggered, turning
OFF the ANTI-CARJACK toggle switch
will have no affect. At this point, Stage
1 begins. Stage 1 lasts for up to 30
seconds.
b. During the 30 seconds, the LED flashes
rapidly.
c. Pressing the VEL switch one
time during the 30 seconds
exits ANTI-CARJACK. Once
ANTI-CARJACK is exited, the
LED turns OFF.
d. If the ignition is switched
OFF at any time during the
30 seconds without first
pressing the VEL switch, Stage 1’s
30-second countdown will pause, but
ANTI-CARJACK will not exit.
The LED will turn OFF. The next time
the ignition is turned ON, Stage 1’s 30-
second countdown will pick up where it
left off.
2. Stage 2
a. Once Stage 1 ends, Stage 2
begins. Stage 2 also lasts for
up to 30 seconds.
b. While in Stage 2, the
LED continues to flash
rapidly, the parking
lights flash, and the
siren continuously
chirps.
c. Pressing the VEL switch at any
time during this stage exits ANTI-
CARJACK provided the ignition is
still ON. (If the ignition is turned
OFF before pressingthe VEL switch,
the alarm jumps to Stage 3, see
below.) Once ANTI-CARJACK
is exited, the lights stop flashing,
the siren stops chirping, and the
LED turns OFF. The alarm can now
be used as normal.
3. Stage 3
a. Once Stage 2 ends,
Stage 3 immediately
begins.
b. While in Stage 3, the LED
remains rapidly flashing, and
the parking lights continue to
flash. However, the siren sound
changes from chirping to a full
blast (sound continuously). The
lights flash and the siren sounds
until the emergency disarm
procedure is performed or until 30
seconds after the ignition is turned
OFF.
c. The starter disable output is
engaged. This means
that turning the ignition
OFF or pressing the
VEL switch one time will have no
effect. The emergency disarm
procedure must be performed in
order to exit ANTI-CARJACK and
start the engine.
