GSM1208 Quad Band SA-G User Manual
GSM1208PB001MAN
3
Version 1.02 – 04/05/06
2 Regulatory
Compliance
2.1 FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone
configuration, which demonstrated that the GSM1208 SA-G complies with Part
15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIG
"modular approval" process for a transmitter. This approach, described by FCC
Public Notice DA 00-131407 released June 26, 2000, is intended to afford relief
to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM1208 SA-G without additional FCC certification
approvals, the installation must meet the following conditions:
For the transmitter to meet the MPE categorical exclusion
requirements of 2.1091, the ERP must be less than 1.5 watts for
personnel separation distance of at least 20 cm (7.9 in). Therefore, the
maximum antenna gain cannot 3.3dBi. If greater than 1.5
watts exists, then additional testing and FCC approval is required.
2.2 R&TTE -
The GSM1208 SA-G modem has been fully tested and complies with
all the requirements of EN301 489-1, EN301 489-7 and EN60950-
1:2001. Compliance to EN301 511 has been demonstrated by testing
on both the GSM1208 and the integrated GSM0108 module.
2.3 Disclaimer
The information and instructions contained within this publication comply with all
FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes that are in effect at
the time of publication. Enfora disclaims all responsibility for any act or
omissions, or for breach of law, code or regulation, including local or state codes,
performed by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc.,
be performed by persons who are experienced in the fields of radio frequency
technologies. Enfora acknowledges that the installation, setup and transmission
guidelines contained within this publication are guidelines, and that each
installation may have variables outside of the guidelines contained herein. Said
variables must be taken into consideration when installing or using the product,
and Enfora shall not be responsible for installations or transmissions that fall
outside of the parameters set forth in this publication.
