Enfora EDG0200, Руководство пользователя

Страница: 11 / 27

Installing the PCMCIA Card into a Laptop
The EDG0200 Card is a standard Type II PCMCIA card that should work in most laptop
computers. Follow these instructions to install the card into your laptop.
1. Find the PCMCIA slot on your laptop. Typically the slot is located on the side of
your laptop.
2. Install mobile PhoneTools from the accompanying CD. This installation will also
install the drivers for the EDG0200 Card.
3. After you install the software, you will be prompted to insert the EDG0200 Card
into your laptop.
4. Insert the EDG0200 Card into the PCMCIA slot. You should hear a tone from
your laptop when the card is seated in the slot.
To remove from the Laptop:
Follow your laptop and operating system instructions for the steps required to remove a
PCMCIA device.
Note: Some operating systems may require you to stop certain services, such as
the PCMCIA service, prior to physically removing the EDG0200 Card.
System Requirements
Check your hardware and software to see if they satisfy the requirements below. If you
are not sure, please consult your dealer or operator.
1. A valid SIM that has been data-enabled by your network operator.
2. A laptop with Windows 2000 or Windows XP and an available PCMCIA slot.
Installing mobile PhoneTools
In order use the EDG0200 Card to make an EDGE connection, you will use mobile
PhoneTools, which is provided on the CD that came with your EDG0200 Card.
Note: Install the mobile PhoneTools software
before inserting the EDG0200 Card into the
PC slot.
EDG0200UG001 Page
5 12/12/2005