IMPAQ™
Owner’s Manual
AM-IMPAQ-OM
Rev AB October 2018
17
PASSWORD
This is where the password is entered to gain access to service level menus by authorized
EnerSys
®
service personnel.
CHARGING THE BATTERY
At this point, the charger should have been set up by a qualified service person. Charging can
only begin when a battery of the proper type, capacity and voltage is connected to the charger.
With the charger in wait mode (no battery connected) and without pressing the Stop/Start button,
the display will show the following information:
Charger Idle Display
Ref.
Description
1
Charger DC voltage/Charge current
2
Firmware version
3
Selected charge profile
4
System time
5
System date
6
Connect battery
S11
Starting a Charge Cycle
The charger will start automatically when a battery is connected or if the Stop/Start button is
pushed if the battery is already connected.
Delayed Start
If the charger was programmed for delayed start, charging will begin following that delay. When
the battery is plugged in to the charger, the display shows the time remaining before the
programmed charging starts.
3
4
2
1
5
6
