For more information visit www.alpha.com
Page 3 of 3
Copyright © 2019 Alpha Technologies. All Rights Reserved. Alpha® is a registered trademark of Alpha Technologies.
0470452-TAB Rev A (04/2020)
Other product names mentioned in this document may be registered in certain jurisdictions. Information is subject to change without notice.
F-MKT-04 Rev 1.4
2.
Route a length of #6 AWG tinned solid copper conductor from a junction point with the VGR
at a location below the cabinet to the Enclosure MGB, located on the right-side wall. Connect
the length of conductor to the VGR via an irreversible compression connector or exothermic
weld and connect the other end to the Enclosure MGB using a suitable two-hole compression
lug. The enclosure MGB accepts a two-
hole lug with 3/8” holes on 1” centers
(refer to Figure
2).
Note:
Avoid tight radius bends and route the conductor such that it intersects with the VGR in
a downward manner as illustrated in Figure 1.
For additional assistance or if you have any questions regarding this notification, please contact
Alpha Technical Support at 1-888-462-7487 or
www.alpha.ca/report-a-problem.
Sincerely,
Satheesh Hariharan
David Veraguth
Sr. Product Manager, Outside Plant Solutions
Sr. Technical Support Representative
Alpha Technologies Ltd.
Alpha Technologies Ltd.
For assistance, contact Alpha Technical Support:
Toll Free North America: 1-888-462-7487
International: +1-604-436-5547
Monday - Friday, 7:00 AM - 5:00 PM PST for regular inquires
24/7 for emergency support
Figure 2
–
TE33-1820 RPN Enclosure Master Ground Bar Wiring
