9.0 Start Up and Verification, continued
94
704-939-B10-001 Rev. A5 (06/2019)
Specifying atidoc33.cfg name and location via DHCP Tags
In the User-defined area of the DHCP Tags, above option 192, the Communications Module will look for the following
value:
Tag: [Insert Unique Tag Name, e.g. ‘ati-tag’]
Value: aticonfig
In the Tag value immediately following will be the value for the TFTP server to use:
Tag: [Insert Unique Tag Name, e.g. ‘ati-ip’]
Value: IP address of TFTP server (i.e. 192.168.1.51)
Immediately following will be the value for the config filename:
Tag: [Insert Unique Tag Name, e.g. ‘ati-name’]
Value: =atidoc33.cfg (an equal sign needs to be in front of the filename for the DHCP server to recognize this as a valid
entry)
9.5.4 Dual IP SNMP Community Strings
The Communications Module community strings used for the CPE Communications Module in Dual IP mode can be
configured by the operator. The default Communications Module read-only community string is AlphaGet. The default
read-write community string is AlphaSet. These settings can be configured with the DOCSIS Configuration File, the DM3.0
Setup File (aitdoc33.cfg) or remotely using SNMP by including the parameters below:
Table 9-7, Community Strings
Community Strings
MIB Parameter
Object ID
Description
Value
atiMgmtSnmpCommGet 1.3.6.1.4.1.926.1.3.1.4.1.0 Read Community String
AlphaGet (default)[desired value]
atiMgmtSnmpCommSet 1.3.6.1.4.1.926.1.3.1.4.2.0 Read-Write Community String AlphaSet (default)[desired value]
These community strings are only applicable for CPE access in Dual IP mode. CM access in both Single
IP and Dual IP modes use standard DOCSIS community strings set through the modem configuration file’s
docsDevNmAccessTable. See
Sections 3.3.1 and 3.3.2
.
NOTICE
:
