Enersol Pool Panel Installation Guide
15 |
P a g e
MAINTENANCE AND
TROUBLESHOOTING
Header or Rubber Replacement
Any header section or length of rubber can be
replaced. To remove the rubber, push the rubber off
with a flat screwdriver. Attach tubes to the headers
by simply sliding them over the nipples. Warm the
ends of the tubes in hot water momentarily. Push
each tube on until it contacts the header and
completely covers the nipple. No clamps are
needed.
Tube Repair
Small isolated holes a splicer can be inserted to
repair small isolated holes.
For repair parts contact your Enersol Dealer or call
1-800-884-6444
If a Section Develops a Leak
Allow 5 or 10 minutes for the O-ring to seat. Replace
O-ring if marked, pinched, nicked or cut. Use O-ring
lubricant as supplied.
WINTERIZATION OF YOUR SOLAR
SYSTEM
Winterization must be done after your pool is closed.
1)
Go to the highest point of the solar panels
and pipes and open the top corner end cap.
Remove the opposite bottom corner end
cap. Without disturbing the top and bottom
rows of headers, work your way along the
panels and gently lift the rubber from top to
bottom. If in doubt you can open a section
and drain out excess water. Blowing the
lines with a shop-vac may not remove all of
the water.
2)
Open all the end caps at down pipes, pump
house and blow any underground lines.
Make sure that no water remains in any low
pipes, sags in pipe valleys or any part of the
system. Reattach the end cap to ensure
nothing enters header.
3)
Valves must be turned to be halfway open or
closed. On motorized valves, turn switch to
TEST
and let valve turn halfway. Pull the
electric cord.
