Enerpac XA-Series, Инструкция по эксплуатации

Страница: 3 / 16

3
Failure to comply with the above or the following DANGER, WARNING and CAUTION paragraphs could
cause equipment damage and personal injury.
Immediately replace worn or damaged parts by genuine ENERPAC
parts. Non genuine Enerpac parts may break causing personal injury
and property damage. ENERPAC parts are designed to fit properly
and withstand high loads.
Stay clear of loads supported by hydraulics.
A cylinder, when used as a load lifting device, should never be used
as a load holding device. After the load has been raised or lowered,
it must always be blocked mechanically.
Only use hydraulic cylinders in a coupled system.
Never use a cylinder with unconnected couplers. If the cylinder
becomes extremely overloaded, components can fail catastrophically
causing severe personal injury.
Use only rigid pieces to hold loads.
Carefully select steel or wood blocks that are capable of supporting
the load. Never use a hydraulic cylinder as a shim or spacer in any
lifting or pressing application.
Avoid situations where loads are not directly centered on the
cylinder plunger. Off-center loads produce considerable strain on
cylinders and plungers. In addition, the load may slip or fall, causing
potential danger.
The system operating pressure must not exceed the pressure rating
of the lowest rated component in the system. Install pressure gauge
in the system to monitor operating pressure. It is your window to see
what is happening in the system.
Do not exceed equipment ratings. Never attempt to lift a load
weighing more than the capacity of the cylinder. Overloading causes
equipment failure and possible personal injury. The cylinders are
designed for a max. pressure of 700 bar/10,000 psi/70 MPa. Do not
connect a jack or cylinder to a pump with a higher pressure rating.
Wear proper personal protective gear when operating hydraulic
equipment.
Be sure setup is stable before lifting load.
Cylinders should be placed on a flat surface that can support the
load. Where applicable, use a cylinder base plate for added stability.
Do not weld or otherwise modify the cylinder to attach a base or
other support.
Avoid damaging hydraulic hose.
Avoid sharp bends and kinks when routing hydraulic hoses.
Using a bent or kinked hose will cause severe back-pressure.
Sharp bends and kinks will internally damage the hose leading to
premature hose failure.
Do not drop heavy objects on hose.
A sharp impact may cause internal damage to hose wire strands.
Applying pressure to a damaged hose may cause it to rupture.
Distribute the load evenly across the entire saddle surface.
Always use a saddle to protect the plunger.
Do not lift hydraulic equipment by the hoses or swivel couplers.
Use the carrying handle.
Keep hydraulic equipment away from flames and heat.
Excessive heat will soften packings and seals, resulting in fluid leaks.
Heat also weakens hose materials and packings. For optimum
performance do not expose equipment to temperatures of 65 °C
[150 °F] or higher. Protect all hydraulic equipment from weld spatter.
Hydraulic equipment must only be serviced by a qualified hydraulic
technician. For repair service, contact the Authorized ENERPAC
Service Center in your area. To protect your warranty, use only
ENERPAC oil.
Use of an air line lubricator is strongly recommended. Set the
lubricator to provide one drop of oil per minute of continuous
operation. Use a high quality air tool oil such as Mobil Almo 525,
Shell Torcula 32 or equivalent.
Indicates a potential danger that requires correct procedures or
practices to avoid possible serious personal injury or death. Is used to indicate correct operating or maintenance procedures and
practices to prevent minor or moderate injury or damage to / destruction
of equipment or other property.
Safety