Enerpac EBH35, Инструкция

Страница: 8 / 20

8
Repeat steps 3 through 5 for each hydraulic connection:
3. Unscrew the threaded collar of the female coupler
from the threaded flange of the male coupler.
4. Disconnect the couplers. Remove any oil, dust or dirt.
5. Reinstall the coupler dust caps.
6.3 Electrical Connections
An electrical cable connects the pump electrical circuits
to the push button controls mounted on the cutter. This
cable is included as part of the hydraulic hose and
electrical cable subassembly. See Figure 3.
Connect the electrical cable as described in the following
steps. Refer to Figures 2 and 3.
1. Be sure that pump is disconnected from AC power
supply.
2. Connect one end of the electrical cable to the
electrical connector at the pump electrical control
box.
3. Connect the other end of the electrical cable to the
electrical connector at the cutter.
To P
ump
2
1
1
6.4 Pump Setup
Prepare the pump for operation as described in the
pump instruction sheet.
Before connecting the pump to the cutter, verify that the
pump relief valve is set at 10,150 psi [700 bar].
If the pump and/or cutter is being used for the first time,
be certain to bleed air from the hydraulic system as
described in Section 8.4 before using the cutter.
Verify that pump oil level is correct and that there are no
oil leaks or other obvious problems.
Figure 3, Hydraulic and Electrical Connections at Pump
Key:
1. Hydraulic Hoses and Couplers
2. Electrical Connectors and Cable