Enerpac EBE26, Инструкция

Страница: 18 / 24

18
1. Be sure that the cutter piston is fully retracted. If not, start
the cutter and cycle the piston until it is fully retracted.
NOTICE
If the piston will not retract in step 1, loosen the
piston release screw and manually retract the piston. See
Section 11.2 for procedure.
2. Disconnect cutter from AC power supply to prevent
accidental motor startup during the following steps.
3. Place the cutter horizontally on a stable work surface
with the oil reservoir cap facing upwards.
4. Remove the moving blade screws and lock washers.
5. Remove the worn moving blade and replace it with
the new moving blade.
NOTICE
If needed, use a screwdriver or small pry bar to
separate the worn moving blade from the mating surface
of the piston.
6. Secure the new moving blade with the new moving
blade screws and lock washers included with the new
moving blade. Torque to 52.9 in-lb [5.98 Nm].
7. If loosened, tighten the piston release screw. For
instructions, refer to Section 8.2.
8. Test cutter for proper operation before placing it back
into service.
10.6.3 Blade Replacement - Moving Blade
Replace the moving blade as described in the following
steps. Refer to Figure 11, items 1, 2 and 3.
Figure 11, Moving Blade Replacement
2
3
1
Key:
1. Moving Blade Screws
2. Lock Washers
3. Moving Blade