to hot wire, red lead to load wire, white lead to neutral wire, green lead
Occupancy Mode:
Best:180 sq.ft.
The coverage range of the sensor switch is specified and illustrated
- 01-
-03-
-02-
DESCRIPTION
HMOS
HMOS
OCCUPANCY / VACANCY
Voltage .......................................................................... 120VAC, 60Hz
Incandescent ........................................................................… 500W
Motor ...................................................................................…… 1/8Hp
Time Delay..............................................…… 15 Sec, 15 Mins, 30 Mins
SPECIFICATIONS
SENSOR SWITCH
(2-IN-1)
INSTALLATION
Turn off the circuit breaker before installation.
WARNING:
Do not exceed electrical ratings.
3. Gently position wires in wall box, attach sensor switch to the box.
2. Device “TOP” upward.
4. Restore power at circuit breaker or fuse, wait one minute.
INSTALLATION INSTRUCTIONS
Light Level...................................................................... Default setting
Indoor use only.
OCC
Mode
VAC
Description
after set time delay.
Position
Upper side
Vacancy Mode: Manual On only,
Automatic Off after set time delay.
Function of ON/OFF button
Manually push
Manually push
Automatic On, Automatic Off
1. Connect lead wires as shown in wiring diagram (see Figure 2): Black lead
causing the light turns even though someone is still in the detection area.
The passive infrared sensor detects the difference between heat emitted
from the human body in motion and the background space. The sensor
in Figure 1. Large object and some transparent barriers like glass
windows will block some degrees of the sensor's view and prevent detection,
Coverage Area
switch can turn a load on and hold it as long as the sensor detects
occupancy. After no motion is detected for the set time delay, the load turns
off automatically.
On/Off the load.
On/Off the load.
to ground wire.
Operation Temperature.................................................... 32° F--131° F
Regular: 450 sq.ft.
Maximum: 700 sq.ft.
30'
Top View
15'
7.5'
15'
7.5'
15'
5'
4'
Lower side
ADJUSTMENT
5. Locate the toggle switch on both sides of the top cover to perform
test and adjustment.
Default position
Adjustable
15 Seconds
15 Minutes
30 Minutes
15 Seconds (Test mode)
Neutral
White
Top
Hot
Black
Ground
Green
Neutral
-02-
White
Load
Red
Load
Figure 4
TOP
INDOOR
USE ONLY
Test
15 MIN
30 MIN
Test
15 MIN
30 MIN
VAC
OCC
VAC
OCC
Mounting Yoke
Fresnel Lens
LED Indicator
Control Top Cover
The switch ships with top cover attached. It is convenient for
Push down top cover to release
OPEN
CLOSE
Line up tabs and push up to attach
Figure 2
Figure 1
Changing the color of your switch
Wiring diagram
1.
2.
Band switch prescription
Time delay setting
Figure 3
(ON/OFF Button)
Ambient light(Default setting)
If the ambient light level is too high, more than the default setting,
the load may not automatic turned ON, If turning ON is desired,
Notice:
users to change the top cover. Please proceed as follows:
Resistive ............................................................................................ 5A
Ballast........................................................................................500VA
cover the sensor lens with one hand for 2 seconds, the light is
going to turn ON.
