Energy Tech Laboratories Modular Direct Fired Heaters, Инструкция по установке и эксплуатации

Страница: 28 / 28

28
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN
AIR BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)
Job Information
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-Up Date
Heater Information
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information
Field Measured Information
Model Number Motor Voltage
Serial Number Motor Amperage**
Motor Volts RPM
Motor Hertz Burner Differential Pressure in. w.c.
Motor Phase Pilot Flame Signal VDC
Motor FLA Low Fire Flame Signal VDC
Motor HP High Fire Flame Signal VDC
Blower Pulley Gas Type
Motor Pulley High Fire Inlet Gas Pressure in. w.c.
Belt Number Low Fire Manifold Gas Pressure in. w.c.
Gas Type High Fire Manifold Gas Pressure in. w.c.
Min. Btu/Hr Thermostat Set-Point
Max. Btu/Hr Temperature Control Discharge
Space
Airflow Direction Correct
Incorrect
**
If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the
measured amps below the nameplate FLA rating.
Maintenance Record
Date Service Performed
Factory Service Department
Phone: 1-866-784-6900
Fax: 1-919-554-9374