4. Place the rubber gasket over the
remaining three screws, route the wires
exiting the top of the fan motor through
the canopy ring (make sure the slot
openings are on top), then proceed to
place the ceiling canopy over the collar
at the top of the motor (Figure 9).
5. Align the mounting holes with the holes
in the motor and fasten, using the three
screws and lock-washers removed in
step 3 (Figure 9).
6. Tighten the mounting screws securely.
5.
Figure 8
“Close-to-Ceiling”
Mounting
1. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting plate (Figure 5).
2. Remove the decorative canopy bottom
cover from the canopy by depressing
the three studs (Figure 7).
3. Remove three of the six screws and lock
washers (every other one) securing the
reinforcing plate to the top of the fan mo-
tor housing (Figure 8).
(3 of 6 Screws)
Figure 9
(3 Screws)
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 6 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
Figure 7
