background image

8

 

 

 

This device complies with part 15 of the FCC Rules. Operation is  
subject to the following two conditions: 

 

(1)  This device may not cause harmful interference, and (2) this device must accept  

any interference received, including interference that may cause undesired operation.  

 

      Changes or modifications not expressly approved by the party responsible for   

compliance could void the user's authority to operate the device. 

 

NOTE: 

This equipment has been tested and found to comply with the limits for  

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are   

designed to provide reasonable protection against harmful interference in a  

residential installation. This equipment generates, uses and can radiate radio   

frequency energy and, if not installed and used in accordance with the  

instructions, may cause harmful interference to radio communications. However,  

there is no guarantee that interference will not occur in a particular installation. If  

this equipment does cause harmful interference to radio or television reception,  

which can be determined by turning the equipment off and on, the user is  

encouraged to try to correct the interference by one or more of the following   

measures: 
—Reorient or relocate the receiving antenna. 
—Increase the separation between the equipment and receiver. 
—Connect the equipment into an outlet on a circuit different from that to which the  

receiver is connected. 
—Consult the dealer or an experienced radio/TV technician for help.  

 

This device contains licence-exempt transmitter(s)/receiver(s) that  
comply with Innovation, Science and Economic Development  
Canada’s licence-exempt RSS(s). Operation is subject to the  
following two conditions: 

 

(1)  This device may not cause interference. 

(2)  This device must accept any interference, includ ing interference that may cause 

undesired operation of the device. 

 

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme 
aux CNR d’Innovation, Sciences et Développement économique Canada applicables   
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions 

suivantes : 

 

1) 

L’appareil ne doit pas produire de brouillage; 

2) 

L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage   
est susceptible d’en compromettre le fonctionnement. 

 

model no. ENJ1000  |  contact us 1-866-295-6775

 

W

IR

E

L

E

S

S

 CH

A

RG

E

R

 

Содержание ENJ1000











Отзывы: