Energetics POWER RUN 3.5, Руководство пользователя

Страница: 5 / 29

5
Upfolding
Hold onto the area (A) with one of your hands. Pull
up the running deck (move towards main frame)
until the safety knob (96) is fixed in the black block
(14).
Unfolding
Fix the running deck with one hand. Pull out the
knob (96) with the other hand and lightly pull down
the running deck. You may then let go the running
deck (A), as the treadmill will slowly fold down
automatically.
Cleaning
Routine cleaning of your treadmill will extend the product’s life.
Warning :
To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is
unplugged from the wall electrical outlet before attempting and cleaning or maintenance.
Important :
Nover use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep
liquids away and keep it out of direct sunlight.
After each workout :
Wipe off the console and other treadmill surfaces with clean, water dampened soft cloth
to remove excess perspiration.
Weekly :
Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt
and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week .
Deck Lubrication
The walking belt has been pre-lubricated at the factory. However , it is recommended that the warking board be
checked periodically for lubrication to ensure optimal treadmill performance. Your treadmill should not have to
be lubricated usually within the first year or 500 hours of use.
Every 30 days or 30 hours of operation lift the sides of the walking belt and feel the top surface of the walking
board as far as you can reach. If you signs of silicone, no further lunrication is required. If it feels dry to the
touch, follow the instructions below. Please use a non-pertroleum based silicone.
To apply luburicant to the walking belt:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the luburicant can.
3. While lifting the side of the walking belt, position the spary nozzle between the walking belt and the
board approximately 6 seconds from the front of the treadmill. Apply the silicone spary to the walking
board, moving from the front of treadmill to the rear. Repeat this on the other side of the belt. Spary
approximately 4 seconds on each side.
4. Allow the silicone to “set” for 1 minute before using the treadmill.
Handling