WARNING
• Risk of Electric Shock - when used outdoors, install only to a covered Class A GFCI
protected receptacle that is weatherproof with the power unit connected to the receptacle. If
one is not provided, contact a qualified electrician for proper installation. Ensure that the
power unit and cord do not interfere with completely closing the receptacle cover.
• The low voltage direct burial cable shall
(a) be protected by routing in close proximity to the luminaire or fitting, or next to a building
structure such as a house or deck;
(b) not be buried except for a maximum 6 inches (15.2 cm) in order to connect to the main
low voltage cable; and
(c) have the length cut off so that it is connected to a connector within 6 inches (15.2 cm)
from a building structure, a luminaire, or fitting.
• Expansion sets are available for additional luminaires to be installed on the same power
supply circuit, note that each power supply can only allow a maximum of ten (10)
luminaires to be linked on the same circuit cable; total luminaire wattage not to exceed
48W per power supply circuit.
3
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time:
20 minutes
SAFETY INFORMATION
PREPARATION
4
INSTALLATION INSTRUCTIONS
1.
Assemble the power supply/controller (A), pathlight fixtures (B) and directional spotlight
fixtures (C) by turning each component into it’s corresponding adjacent part’s threaded fitting.
The power supply/controller (A) consists of 3 parts: controller body, extension tube, and
mounting stake.
The pathlight fixtures (B) each consist of 3 parts: light head, extension tube, and mounting
stake.
The directional spotlight fixtures (C) each consist of 2 parts: light head and mounting stake.
NOTE:
The power supply/controller (A) and pathlight fixture (B) requires that the cord at the
base of the extension tube be passed through the slot opening before the stake can be
attached to the extension tube threading.
Fig. 2
2.
Determine the desired location for each piece of the kit. Note that the power supply / controller
(A) assembly will need to be located near a power outlet within the distance provided by the
power cord to the outlet plug adapter.
NOTE:
Do NOT push the fixture top when inserting the stakes into the ground, press down only
on the round base of the stake as shown in fig. 2 above. If the ground is too hard-packed,
use a screw driver or similar tool (not provided) to loosen the soil and pre-punch the stake
path.
60-ft of direct burial cable is provided with each kit package, however, expansion sets are
available (sold separately) providing additional fixtures and direct burial cable.
NOTE:
A maximum of 10 fixtures can be installed on a single power supply circuit.
A
B
B
C
Fig. 1
INSTALLATION INSTRUCTIONS
Slot
Opening
Cord
Path
A
B
C