850W ROTARY HAMMER ENB465DRH
HAMMER/DRILL SWITCH
The hammer/drill switches can switch the drill, hammer and hammer/ drill functions.
There is a lock knob in front hammer/ drill switch, please depressed it first to preventing any unintentional
adjusting.
WRNING!
Please check and make sure the function switch has been fixed by locking knob after each adjustment.
To set the function, please use below compounding of front and rear hammer/drill switch:
Hammer drilling mode:
Set the
front hammer/drill switch
to the position
and
the rear
hammer drill switch
to the position
.
This setting is recommended for use when drilling holes
in concrete and other masonry products. The hammer
action will be in operation while simultaneously the drill
bit rotates
Hammer mode:
Set the
front hammer/drill switch
to the position
and
the rear
hammer drill switch
to the position
. This
setting is recommended for use when you desire a
hammer action without the accessory rotating which is
ideal for “chiseling or chipping” away at masonry
products, chisel accessory bits should be used.
Drilling mode:
Set the front hammer/drill switch to the position
and the rear hammer drill switch to the position . This
setting is recommended for use when you desire the
accessory to rotate without hammer action. Ideal for
drilling into timber or steel when the correct accessories
for such materials are used.
WARNING
No function mode:
The motor turns without load, the shaft will not turn.
Do not set the switch like this. It may damage the motor
greatly.
