background image

Instant Battery Power Check

Press the Smart button on the side briefly and the level 

of the internal battery of the charger will be dispayed 

on the status LED lights. 

During the output charging,  

press push button P/C to check battery power available 

in the unit. This will be indicated by the 4 status lamps 

which will illuminate for several seconds

Charging your mobile device

1. Connect your mobile device to the charger via the 

USB cable and the correct connector for your device.  

2. Initiate charging with a 2 second press of the Smart 

button on the side of the unit. The red charging light 

will illuminate indicating charging in progress. 

3. When the mobile device is fully charged, charging 

will terminate automatically and the red light will extin-

guish.

4. Charging can also be manually terminated at any 

time by pressing the Smart button for 2 seconds. 

Note 1:  If the Smart button is pressed as above and no mobile 

device is attached or the device is fully charged, the charger will 

detect this and switch off charging after 30 seconds.

Note 2:  If the charger battery level becomes low, the green LED 

will flash continuously for 5 minutes and the charging process 

will then terminate.

Note 3: In-built over-discharge protection prevents damage to 

the internal battery of the charger

Out of the Box

Before the charger is used for the first time, it 

must be charged via a computer USB port or 

similar for at least 2 hours.

USB

Phone

Charger

F

L

IN

OUT

LED

Po

w

er/Char

ge

/L

ED

Features

USB output charger port 

Solar or miniUSB input charging port

Fixed voltage constant current charging

LED Torch: normal, bright, flashing, SOS

LED status display: charging, discharging, battery 

level, low battery.

Torch 

1. The  LED torch is operated by pressing the smart 

button for longer than 2 seconds. 

2. The display will cycle through 4 display modes   

with each successive short button press:  

        normal -> bright -> flashing -> SOS

3. Holding the button down will turn the torch off.

Charging via sunshine and USB

The internal Lithium ion battery is charged either from 

the sun or via its mini USB port.

a. Place directly under strong sunlight.  A green light 

indicates solar charging.

b. Connect the charger using the USB cable supplied 

via the MiniUSB port of the charger to a laptop, PC, car 

charger or other USB source.  Charging will start auto-

matically.  

Instant battery level will be shown on the four status 

lights. When all four lights stay on without flashing, the 

battery is fully charged.  

During charging of the charger itself, the button is 

inhibited from use. 

Note: Over-charge protection prevents  damage to the internal 

battery.

1

2

3

4

5

6

IN

OUT

LED

F

L

100% Full
75%
50%
25%
Solar charging
Charging 

1. Solar panel
2. Smart button
3. Status lights
4. MiniUSB port (in)
5. USB port (out)
6. LED torch light

Car charger

AC adaptor

Отзывы: