www.ener-j.co.uk
6
Installation Method
Trouble-Shooting
Normal Maintenance
1. For the first time to operate the appliance, please fill with the water before bringing power to the appliance.
2. Turn on the circuit breaker or plug in the socket to bring power to the electric hot water tap.
3. In standby mode, the LED display screen light on and display the setting outlet temperature, after 2 seconds, it will display
the outlet temperature.
4. Touch to turn on/off the power of the power of appliance. Press + and – to increase or decrease the outlet temperature.
5. While rotate handle toward to the appliance keep closed mode,
6. While you rotate the hand shank toward to
the cold water will come out; Rotate the knob anti-clockwise, the cold
water flow will be larger & larger.
7. Rotate the handle shank to
the hot water comes out, Rotate the knob clockwise, the hot water flow will be larger &
larger, meanwhile the program will mini adjust the working power to reach the setting temperature.
8. The nozzle is rotatable in 180°
1. Install a filter in the front-end of water inlet of the electric hot water tap.
2. Periodically remove scale and dirt that may build up at the sprayer of the tap.
3. The filter net at the water inlet should be cleaned from time to time. Please turn off the water flow before doing this.
4. If you will not use this appliance for long time, please disconnect the plug.
WARING: if the outlet temperature can not reach the setting temperature, maybe because the water flow is too high, please
reduce the hot water flow.
Note: Always turn off the power supply before servicing your unit.
It is not required any regular maintenance. However, to ensure consistent water flow, the following maintenance is
recommended.
1. Inlet and outlet fittings leaking
A. Fittings not tight
B. Rubber washer worn-out
A. Tighten fittings
B. Replace rubber seal ring
2. Keep the hand shank in close mode,
but there is still water come out
A. Valve core failure
B. Valve body failure
A. Contact local service
B. Contact local service
3. Outlet water flow bifurcate / Outlet
water flow is too small
A. Filter net of bubbler scale or blocked
by impurity
B. Inlet water pressure is too low
A. Disconnect the bubbler and clean the
filer net.
B. Increase the water pressure
4. There is noisy while turn off the water
flow
A. Water pressure is too high
B. Turn off the hand shank too fast
C. The water pipe wasn’t fixed well
A. Turn down the water flow
B. Turn off the hand shank again
C. Reconnect the pipe
5. While touch the hot water, hands feel
a little tingling.
A. The appliance is not properly earthed.
A. Connect the earth line properly
6. No heating
A. No power supply
B. The knob didn’t toward to hot water
position
C. The power board keep off mode
D. Manual Reset thermal cut-out cut off
E. Heating element failure
A. Correct power supply
B. Toward the knob to hot water
position
C. Press *** to turn on the power board
D. Contact local service
7. Too high outlet temperature
A. Setting temperature is too high
B. Thermal Cut-out cut off
A. Touch “-” to decrease the temperature
B. Contact local service
8. Outlet water flow gest smaller &
smaller
A. Inlet strainer or bubbler was blocked
B. Inlet water pressure become lower
A. Clean strainer or bubbler
B. Increase the inlet water pressure
9. Display E1
A. Outlet temperature ≥58°C
A. Please make sure there is water
supply, shut off the power supply
then power on again, the E1 will
disappear
10. Display E3
A. Outlet temperature sensor failure
A. Replace outlet temperature sensor
Possible Causes
Corrective Actions
Problems
