P a g e
|
2
4.
Insert the round washer (#6) onto the base (#4) and insert the M6*20 screws (#5). Screw on tight with the
provided Allen Key.
5.
Stand the unit correctly (Fig. B). Fix the L Shaped Bracket (#8) onto the Alum. Fixtures (#7) with the M8*6 screws
(#9) & M4*6 screws (#10) respectively. Then slide the L shaped Bracket (#8) into the holes of the Control Box
(#11).
6.
Fix the L shaped Bracket (#8) onto the Control Box (#11) with the M6*16 Screws (#12).
Make sure the heater is not connected to a wall outlet before placing it where it will be used.
NOTE:
wait until the heater heating element has cooled down before moving it.
REMEMBER,
portable electric heaters are designed for spot heating or as a supplementary heat source. They are not
intended to be the main source of heat during cold months.
Caution:
1)
If you must use an extension cord, the cord should be at least NO .14 AWG and rated for no less than
1875 W.
2)
You must always make sure there is at least 6’’/15 cm of empty space around the heater.
3. OPERATION
1) Press the power button on the Heater to activate or deactivate it. Press the LED light button to activate or
deactivate it.
4. FOR YOUR SAFETY
IMPORTANT INSTRUCTIONS