9
EN
CAUTION:
• Transmitter/receiver boot time requires 30 seconds.
• Transmitter must be rebooted to apply channel setting by
hardware rotating switch.
• Not recommend to work with existing LAN connection to
avoid large video, data transmission or multicast packets to
slow down your other LAN devices.
• Gigabit switching hub must support IGMP and Jumbo
Frame over 8K in order to achieve the best quality.
• If monitor shows green screen, please check if the switch
running under gigabit and IGMP/Jumbo Frame function
enabled.
• If video not smooth please check if IGMP function enabled
or bandwidth of switch closes to maximum.
• When using computer or mobile APP management the IP
address should be set in same network segment.
• Computer software and APP operation please refer to
software operating instruction.
• If receiver switch to transmitter which no video input, it will
show blank screen or last still image for a while.
• Fast switch mode might cause screen or audio abnormal
briefly when switch channel.
• In high resolution (like 1080p) the OSD response will be
delayed a little bit.
• If IR remote not work properly, please check the battery
(especial in low temperature) and reset IR ID.
• Audio in is designed for Mic in, not for Line in.
• Screen saver function not support monitors which only
works based on HDMI +5V signal.