Eneo HDC-2080Z03, Инструкция по установке и эксплуатации

Страница: 10 / 20

9
6.3 ZOOM/FOCUS
ZOOM /
FOCUS
Default Descriptions
FOCUS
MODE
ZOOM
PUSH
ZOOM PUSH, AUTO and MANUAL modes are available for focusing.
ZOOM PUSH – Focusing is activated only when zoom in/out is working.
AUTO
– Focusing is working always.
MANUAL – Focusing can only be adjusted by ▲,▼ of OSD control
joystick or the remote control via RS-485.
D-ZOOM OFF
D-ZOOM(Digital zoom) is available up to 32x.
D-ZOOM starts working when the optical zoom reaches its maximum tele-
position. Zoom ratio is displayed on the right bottom corner of the monitor if
SPECIAL>DISPLAY>ZOOM RATIO is set to ON.
LENS
REFRESH
OFF
LENS REFRESH can be set to 1~10day and performs the scheduled LENS
Initialization automatically. Every initialization occurs when the time reaches
the scheduled time after setup or power up.
When LENS REFRESH initiates LENS Initialization, a notification ‘LENS
INITIALIZING…’ appears on the top left corner on the monitor.
LENS INIT
ON
☟
Lens initialization is necessary during the installation or the regular
operation to align the position data with the mechanical positions whose
lens elements may move and deviate from its calibrated position by the
shock or vibration, for example, during the transportation.
LENS INIT starts the lens initialization when pressing the joystick lever
straight down for about 1.5sec.
LENS INIT checks the positions for zoom and focus at both of the end
positions and saves them for the references.
Lens initialization is automatically executed at power up.
CAUTION
It is strongly necessary to execute LENS INIT in cases below;
1) At the final step for the installation.
2) When focus becomes out of control by the shock or vibration
.
ZOOM / FOCUS
FOCUS MODE ZOOM PUSH
D-ZOOM OFF
LENS REFRESH OFF
LENS INIT. ON
RETURN RET
↵