Eneo FASTRAX III, Инструкция по эксплуатации

Страница: 20 / 48

14
5. Select “MODE” and “SPEED”.
6. Select “START ANGLE”. Hold down the
CTRL
key while selecting the start position using the
Joystick
.
Current panning position will be displayed. Release
CTRL
key to complete the selection of the start
position. Or Press
IRIS Open
then the “CTRL” displays. Move the desired position and the zoom
position. Press
IRIS Close
then the “CTRL” disappears. To adjust at the 0.1 degree interval, twist the
Joystick
at the pan field and the tilt field. To adjust at the one zoom interval, twist the
Joystick
at the
zoom field.
7. Select “END ANGLE.” Hold down the
CTRL
key while moving the Joystick to select the end position.
The end position angle should be larger than start position. Release the
CTRL
key to complete the
selection of the end position. Or Press
IRIS Open
then the “CTRL” displays. Move the desired position
and the zoom position. Press
IRIS Close
then the “CTRL” disappears. To adjust at the 0.1 degree
interval, twist the
Joystick
at the pan field and the tilt field. To adjust at the one zoom interval, twist the
Joystick
at the zoom field.
8. Set “SCAN DIR” to CCW or CW.
9. Select “SWAP”. Set to ON, to exchange the start angle and the end angle.
10. Set “DWELL TIME”.
11. Select Save and Exit and push the
Joystick
to the right or press
IRIS Open
. Press
ESC
or
IRIS
Close
to exit the program without saving.
Pressing the
HOME
key delete stored data at the angle field.
To set the position using the preset position:
a. Before entering the Auto Scan menu, select a preset position as a starting point for
Auto Scan.
Example
:
2
+
PRST
and do step 1 to 4. In step 5, just press the
Ctrl
key at the start angle position, the
current position will be displayed as a start position.
b. Save and exit from the menu.
c. In normal mode, call a preset to be the end point of scan. Press
3
+
PRST
then press
Scan
key to
enter the Auto Scan menu. Move the cursor position to END ANGLE. Just press
CTRL
key at the end
angle position. Save and exit from the menu.
Press
SCAN
key on the angle field to display with the small OSD. Then the screen will show as below.
AUTO SCAN AREA SETUP
(CTRL KEY)
NUMBER01
START: ----- ----- ---
END : ----- ----- ---
EXIT(ESC TO EXIT)
The setting procedure is the same as above.
NOTE: 09:AUTO-PAN mode(Endless panning)