DRAFT
DRAFT
DRAFT
DR
DRAFT
DRAFT
DRAFT DRAF
DRAFT DRAFT DRAFT DRA
FT
D
RAFT D
DRAFT
DRAFT
DRAFT DRAFT DRAFT
DRA
FT DRA
Double Repeater User Manual
Intelligent Reliable Power
9
© ENECSYS 2010. All rights reserved.
2.3 Wall mounting the Enecsys Double Repeater (adhesive pad method)
When mounting an Enecsys Double Repeater always ensure that you have connected the power
supply and antenna to the device before the final fit. Locate the Enecsys Double Repeater away
from metal structures.
The adhesive pad placement areas are shown in
Figure 4 on page 8
.
1. Ensure that the back-plate of the Enecsys Double Repeater and the wall or mounting surface
is clean from dust and grease.
2. Connect the supplied external 5V DC power supply to a mains supply AC power source.
3. Connect the supplied external 5V DC power jack-plug to the DC power port on the reverse of
the Enecsys Double Repeater, thread the cable through the semi-circular channel on the back-
plate of the Enecsys Double Repeater, this will help to keep the cable in place and prevent it
from becoming detached.
4. Remove the backing material from one of the double sided adhesive pads and place firmly
onto the fixing points on the back of the Enecsys Double Repeater. Complete the process for
the remaining two double sided adhesive pads.
5. Remove the remaining backing material from the adhesive pads attached to the back-plate of
the Enecsys Double Repeater, press the Enecsys Double Repeater firmly into place on the
wall/mounting surface.
