3
Ultimate Trilennium
®
Astragal Cut Down Instructions
STEP 2 (CONT.): CUT ASTRAGAL TO SIZE
STEP 3: REINSTALL UPPER BOLT
a.
Reinstall the upper trim cap.
b.
Slide the drive rods out to
expose the notches.
c.
Replace the upper bolt into the notches on the
driver rod and slide the bolt back into the astragal
body so the end of the bolt sleeve is flush with the
end of the astragal.
d.
Replace the orange securing
pin into the hole in the bolt sleeve
that aligns with the holes in the
astragal body.
If drive rods are in the way of the cut down, slide further into the astragal or remove
temporarily to avoid damage to them.
!
b.
To renotch the astragal measure 9/16" from the cut end
of the astragal.
Using a chop saw, cut at this point, until the
space between the rows of holes in the astragal body.
Do not
cut it flush.
9/16"
Cut Flush
X
a.
Starting at the
bottom
of the astragal and measuring along the
narrow side
, measure
and mark (X) on the astragal. Cut the astragal flush at this location.
X